- ページ 10

SSD7103 Linux Debian10.3.0 Installation Guide

press "ALT+F2"(Graphical install please press"ALT+F5") to the shell and type the

following commands:

# sh /tmp/hptdd/postinst.sh

A message will be displayed that the driver has been installed successfully.

Press "ALT+F1" to switch back to installation screen and finish the installation.

3 Monitoring the Driver

Once the driver is running, you can monitor it through the Linux proc file system support.

There is a special file under /proc/scsi/hptnvme /. Through this file you can view driver

status and send control commands to the driver.

Note

The file name is the SCSI host number allocated by OS. If you have no other SCSI cards

installed, it will be 0. In the following sections, we will use x to represent this number.

Using the following command to show driver status:

# cat /proc/scsi/hptnvme /x

This command will show the driver version number, physical device list and logical device

list.

HighPoint RAID Management Software is used to configure and keep track of your hard

disks and RAID arrays attached to

software is optional but recommended.

Please refer to HighPoint RAID Management Software documents for more information.

When the system updates the kernel packages, the driver module hptnvme.ko should be

built and installed manually before reboot.

Please refer to the REAME file distributed with HighPoint

on how to build and install the driver module.

← Install SSD7103 driver.

controller. Installation of the management

SSD7103

open source package

- 8 -