- ページ 3

コントローラー HighPoint HPT370のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。HighPoint HPT370 16 ページ。 Ata raid controller for red hat linux

HPT370/372/372A Red Hat Linux Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install and use

HPT37x ATA RAID controllers on Red Hat Linux system.

The driver supports following the HighPoint ATA RAID controllers:

HPT370 UDMA/ATA100 RAID Controller

HPT372 UDMA/ATA133 RAID Controller

HPT372A UDMA/ATA133 RAID Controller

2 Installing Red Hat Linux on HPT370/372/372A

Controller

If you would like to install Red Hat Linux onto drives attached to HPT37x controller, please

perform the following operations:

Step 1 Prepare Y our Hardware for Installation

After you attach your hard disks to HPT37x controller, you can use HPT37x BIOS Setting

Utility to configure your hard disks as RAID 0, RAID 1, RAID 0/1 or JBOD arrays, or just

use them as single disks.

Before installation, you must remove all the disk drives, which are not physically attached

to HPT37x controller, from your system.

Note

If you have other SCSI adapters installed, you must make sure the HPT37x controller

BIOS will be loaded firstly. If not, try to move it to another PCI slot. Otherwise you may

be unable to boot up your system.

In your system BIOS SETUP menu, change Boot Sequence in such a way that the system

will first boot from floppy or CDROM, and then from SCSI. Refer to your BIOS manual to

see how to set boot sequence.

If your BIOS settings do not support such a boot sequence, you can first set it to boot from

floppy or CDROM. After you finish installation, set SCSI as the first boot device to boot

up the system.

If you are installing Red Hat Linux 7.0/7.1, just copy all the files under rhdd directory to a

dos formatted diskette.

- 1 -