- ページ 3

コントローラー HighPoint SSD7505のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。HighPoint SSD7505 14 ページ。 Using nvme raid aics with the dell precision 3930 rack workstation
HighPoint SSD7505 にも：インストレーション・マニュアル (14 ページ), インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (15 ページ), クイック・インストール・マニュアル (6 ページ), クイック・インストール・マニュアル (8 ページ), インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (19 ページ), マニュアルの使用 (19 ページ)

Linux Ubuntu Server on SSD7505 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux

Ubuntu Server on the SSD7505 controller.

2 Installing Linux Ubuntu Server on SSD7505

controller

If you would like to install Linux Ubuntu Server onto drives attached to SSD7505

controller, please perform the following operations:

After you attach your NVMe SSD to SSD7505 controller, you can use SSD7505 EFI

Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.

Before installation, you must remove all the NVMe SSD, which are not physically

attached to SSD7505 controller, from your system.

Note

SSD7505 only support EFI boot. If you have other SCSI adapters installed, you must

make sure the SSD7505 controller EFI will be loaded firstly. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

In your system EFI SETUP menu, change Boot Sequence in such a way that the system

will first boot from EFI CDROM, and then from SSD7505 RAID. Refer to your

motherboard EFI manual to see how to set boot sequence.

If your EFI settings do not support such a boot sequence, you can first set it to boot from

EFI CDROM. After you finish installation, set SSD7505 RAID as the first boot device to

boot up the system.

1. Set UEFI setting with SuperMicro H12SSL -i motherboard as an example.

"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"

to "EFI".Suppose SSD7505 is connected to motherboard CPU1 Slot 2 PCI-E

X16,then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";

- 1 -