- ページ 2

テント DD HAMMOCKS DD SuperLight Pyramid TentのPDF マニュアルをオンラインで閲覧またはダウンロードできます。DD HAMMOCKS DD SuperLight Pyramid Tent 2 ページ。

Setting up the DD SuperLight Pyramid Mesh Tent
You can use a hiking pole to set this tent up or alternatively you can suspend it from a tree using the
toggle on the top of the tent.
1.
Ensuring the entrance is zipped up, spread out the Pyramid Mesh Tent on the ground (it should form a
square).
2. Peg all the corner attachment loops.
3. Extend both sections of your hiking pole to around the 130cm mark. Insert the tip of your hiking pole
into the eyelet in the base of the tent.
You may need to adjust the height of the pole depending on the hardness of the ground. It is
always best not to extend the pole to the maximum initially, as you can adjust the height of the
pole from the inside at any time.
Setting up the DD SuperLight Pyramid Tent
Please note - the corners of the outer tent need to be pegged slightly further out from mesh tent to allow
for air circulation.
1.
Place the outer tent over the mesh tent so the top attachment loop is aligned with the toggle on the
mesh tent.
2. Peg out all the corners very loosely just to mark the space. Make sure the edges are aligned with the
Pyramid Mesh Tent. Put one peg through both entrance attachment loops. Adjust all pegs if needed.
3. Tension all of the loops in the middle of the side walls of the outer tent and peg them out.
4. The side attachment points can be used to achieve wind stability. Use guylines to peg them out if
needed.
5. Guy out the air vent on the back of the tent to allow the air circulation inside the tent.
If not using a hiking pole, then please use an eyelet on the inside of the outer tent to attach the
mesh tent to it.