- ページ 4

ハンモック DD HAMMOCKS Ultralight Hammock StandのPDF 使用方法をオンラインで閲覧またはダウンロードできます。DD HAMMOCKS Ultralight Hammock Stand 5 ページ。

ページを印刷する

Anchoring the guyline ground plates

To anchor the guyline ground plates

plates are top side up):

Once you have pegged all 4 guyline ground plates out you wil be 2 pegs short. Remove them from the strut ground plates.

Step 1

Bring the plastic ball on

the end of the guyline

through the middle of the

guyline ground plate

Pull through around 10cm to

wrap around the pegs later.

Step 4

Take the ball on the end of the guyline

and wind it all the way around the 3

pegs.

Step 8

Assembling the struts

Step 1

The strut will look

like this to begin

with - it needs to

be extended.

Step 2

Insert the first peg

vertically into hole opposite to

the guyline and push it down

as hard as you can. Please do

not stand on the pegs as this

might bend them.

Step 5

Loop the guyline exactly as shown (if

not, the ball will pop out) and pass the

ball through the loop.

Do exactly the same on all the guyline ground plates.

Step 2

Step 3

Slot the 2 halves

Push the central

of the strut pole

mechanism up until

into each other.

the 3 support arms

are at right angles

to the strut, and the

cord is taut.

follow the instructions below (please make sure the ground

Step 3

Insert the second peg at an

angle, crossing behind the

first peg.

Step 4

Take the loose cord

with the toggle on

the end.

Step 4

Insert the third peg so that

the vertical peg is trapped

between the other 2 pegs.

All pegs should be firmly in

the ground without being

pushed all the way.

Step 7

Tug the guyline to

secure the knot.

Step 5

Step 6

Put it through the

Push the central

loop on the top end

mechanism down

of the strut.

until the toggle cord

is taut.