- ページ 5

アウトドアカート adeptus 76152のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。adeptus 76152 7 ページ。 6 drawer roll cart

ページを印刷する

ATTACH CROSSBARS TO THE SIDE PANELS

ATTACH ONE SIDE FIRST AND THEN THE OTHER SIDE.

DO NOT STAND LEFT SIDE (PART 3) UP

•

ON THE EDGE YET. TO EASE ASSEMBLY,

LAY SIDE FLAT ON THE FLOOR, RUNNER

SIDE VISIBLE.

•

MATCH UP BACK CASTER SUPPORT

(PART 6) AND FRONT CASTER SUPPORT

(PART 7) AT DOWEL HOLES LOCATED AT

THE BOTTOM OF SIDE.

• PLEASE CHECK THAT THE DISTANCES

MATCH TO THE SQUARE DIAGRAM.

SECURE BACK CASTER SUPPORT (PART 6) TO THE LEFT

•

SIDE (PART 3) USING SCREW (PART C).

SEE THE ROUND DIAGRAM, A BLOW UP IMAGE OF THE SCREW

POSITIONING TROUGH THE ANGLED POCKET HOLES.

SECURE FRONT CASTER SUPPORT (PART 7) WITH SCREWS

•

(PART C) TO THE LEFT SIDE (PART 3) IN THE SAME MANNER.

CAREFULLY TURN LEFT SIDE (PART 3) TO ITS BACK EDGE,

•

AS SHOWN IN THE DIAGRAM.

POSITION RIGHT SIDE (PART 2) TO LINE UP THE CROSSBARS

•

(PART 6 AND 7) AT THE DOWEL HOLES AT BASE OF THE RIGHT

SIDE (PART 2).

SECURE CASTER SUPPORTS (PART 6 AND 7) TO RIGHT SIDE

•

(PART 2) USING SCREW (PART C) AND SHOWN IN THE DIAGRAM.

TIP: HAND TIGHTEN FOR THE BEST FIT.

ATTACH THE TOP

• LINE UP THE DOWEL HOLES IN TOP (PART 1)

WITH DOWELS THE IN UNIT´S SIDES.

• SEE ROUND DIAGRAM:

SLIDE (PART C) SCREWS THROUGH ANGLED

POCKET HOLES.

AND HAND TIGHTEN FOR BEST FIT.

TIP: Turning the

unit upside

down provides a

better angle to

tighten the

screws.

C= 6

Screw 4,0 x 30mm

NOTICE:

1 1

CONTAINED

TIP: This

C= 4

step is

easier with

two people.

Screw 4,0 x 30mm

C C C C

5-07