- ページ 5
ケーブルとコネクター DDK CM10-SP10S-S(D6)のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。DDK CM10-SP10S-S(D6) 12 ページ。 Plug connector cable
ページを印刷する3-4. Soldering a contact
Apply preliminary soldering to each contact and to the cable's core wire, then solder the core wire to the
contacts.
Contact name
CM10-SP10S-X(D6)
CM10-SP2S-X(D6)
Note! Make sure that the core wire does not come out of the contact.
When soldering, make sure that the solder does not stick to the circumference of the solder
cup.
When using a drain wire, attach a heat shrink tube to the drain cable after soldering.
* When making CM10-SP10S(D6), the cable for No. 10 terminal is 1mm longer than other
cables. (To avoid the cable tension when inserting a contact to the housing in a later
process.)
* The difference in the total A length of the cables for other than No. 10 terminal must be 1mm
or less.
Difference in total length: 1 mm or less
(for other than No. 10 terminal)
Contact
Applicable contact
CM10-#22SC(S1)(D8)
CM10-#22SC(S2)(D8)
29 to 32mm
Drain wire
If a drain wire is soldered
Applicable cable
AWG20 or below
AWG16 or below
A
Enlargement of A area
Core wire
Heat shrink tube
Material No.
TC-605
Soldering
Cable
Page
4/11