- ページ 15
リモコン CopperOptics PairGain PG-Flex FRE-765 List 5のPDF マニュアルをオンラインで閲覧またはダウンロードできます。CopperOptics PairGain PG-Flex FRE-765 List 5 20 ページ。 Remote terminal enclosure
CopperOptics PairGain PG-Flex FRE-765 List 5 にも： マニュアル (8 ページ)
ページを印刷する
Revision 01
8.3
HDSL Lines. Install the HDSL lines (Figure 5):
1
Route the HDSL pairs through the strain relief on the bottom of the enclosure.
2
Terminate HDSL Pair #1 on the Quiet-Front terminals HDSL_1_T (Tip) and
HDSL_1_R (Ring).
3
Terminate HDSL Pair #2 on the Quiet-Front terminals HDSL_2_T (Tip) and HDSL_2_R (Ring).
4
Use a cable tie to secure to the bracket near the cable entrance.
8.4
Bypass Pair. Install the Bypass Pair (Figure 5):
Do not connect metallic bypass pairs between PG-Flex systems or to other DLC
systems.
1
Route the bypass pair through the strain relief on the bottom of the enclosure.
2
Terminate the bypass pair on the Quiet Front terminals BYPASS_T and BYPASS_R.
3
Use a cable tie to secure to the bracket near the cable entrance.
8.5
Subscriber Lines. To install the subscriber lines, do one of the following:
Use the cable adapter (PN 120-1111-02) installed on the RT Enclosure to ensure
the subscriber terminations match the information shown in Tables 5 through 9.
•
For List 5 FRE-765 enclosure:
1
Route the subscriber line cables through the strain relief on the bottom of
the enclosure and connect to P2 and P3 connectors.
2
Terminate the subscriber line cables per Tables 4 and 5.
3
Secure with a cable tie to the bracket near the cable entrance.
•
For List 5A FRE-765 enclosure:
1
Route the subscriber line cables through the desired knockout on the bottom of
the enclosure.
2
Terminate the subscriber line cables per Table 6.
3
Use a cable tie to secure to the bracket near the cable entrance.
PG-Flex FRE-765
June 2, 1997
Figure 5. Installing HDSL Lines and Bypass Pair
PairGain Engineering - Plant Series
Section 363-765-105
Page 13