- ページ 15
アンプ Gallien-Krueger 2001RBPのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gallien-Krueger 2001RBP 20 ページ。 Bass amp and preamp
Gallien-Krueger 2001RBP にも： オーナーズマニュアル (20 ページ)
ページを印刷する
Rear Panel Controls
1. AC Receptacle:
The power cord is detachable and plugs in here.
2. Remote Trigger:
This feature is used when using multiple 2001RB's as
"master" and "slave" units. It allows you to turn on all
amplifi ers at the same time, when the "master" unit is
powered on.
In:
Accepts the +12VDC signal from the "master" 2001RB's
Trigger Out jack to activate or turn on, the "slave"
2001RBs when in standby mode.
Out:
Provides +12VDC as a trigger output to remotely turn on a
"slave" 2001RB.
3. Right "Speakon" Outputs:
Enables BI-AMP operation by connecting a GK-RBH Series
cabinet with the provided 4 conductor Speakon cable.
This connects the 50W amplifi er allowing the Tweeter
control on the front panel to control the signal going to
the horn. See Bi-Amp and Normal Operation on page 7
for more information.
4. Right Speaker Out:
540W power amp output for Full-Range operation only.
They deliver 540 watts into 2 Ohms or 360 watts into 4
Ohms. Lower impedances should not be used.
5. Right Level:
This adjusts the output level of the right channel only in
dual-mono mode.
6. Bridge Mode:
This allows one to switch from Dual/Mono to Bridge
mode.
2001RB & 2001RBP
7. Left Speaker Out:
540W power amp output for Full-Range operation only.
They deliver 540 watts into 2 Ohms or 360watts into 4
Ohms. Lower impedances should not be used.
8. Left/Bridged "Speakon" Outputs:
Enables BI-AMP operation by connecting a GK-RBH Series
cabinet with the provided 4 conductor Speakon cable.
This connects the 50W amplifi er allowing the Tweeter
control on the front panel to control the signal going to
the horn. See Bi-Amp and Normal Operation on page 7
for more information.
These "Speakon" outputs also enable "bridged mode"
operation. When in bridged mode, the 2001RB will be in
a simultaneous bridged/Bi-amp mode, since the 50W horn
amplifi ers are always active ( in the clean channel only)
unless you choose to use the "horn mute" feature, via the
RFB-III footswitch.
DO NOT CONNECT ANYTHING TO THE RIGHT
CHANNEL OUTPUTS WHEN IN BRIDGED
MODE!!
DO NOT USE "BRIDGE MODE" CABLES WITH
THIS AMPLIFIER, AS THIS COULD RESULT IN A
MALFUNCTION AND/OR DAMAGE TO THE
AMPLIFIER.
9. Footswitch:
Provides a means to hook-up the RFB-III, three button
footswitch to your amplifi er, with a standard 5 pin DIN
(MIDI) cable. The RFB-III allows remote Channel Switch-
ing (Level A or Level B), Horn Mute (when in the clean
channel) and Tuning Mute.
10. Direct Out:
Gnd/Lift:
15