- ページ 3
スイッチ HighSecLabs SC82PH-4のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。HighSecLabs SC82PH-4 4 ページ。 8/16 ports high security dp/hdmi kvm combiner switches
ページを印刷するUsing the HSL Combiners:
HSL's 8 Port and 16 Port KVM Combiners have
three layouts for presenting the sources on the
screen:
•
Full screen – one of the 8 or 16 source
PCs is presented on the display in full
screen. To enter this mode, use the: "L
CTRL | L CTRL | f" keyboard shortcut.
•
Quad: All channels are shown on the
connected display. To enter this
mode, use the: "L CTRL | L CTRL | q"
8 and 16 Ports Full Screen layout
Single/Clone
In Extended mode – the second screen will
show the remaining 7 or 15 channels in Quad
Layout
16 Ports Quad Layout
Single/Clone display mode:
8 Ports Scale Layout Single/Clone display
in Extended mode the primary display will show one channel in Full layout
and the secondary in will show the other 7 in Quad
•
Each channel shown has a frame around it
to distinguish between the channel.
•
To select a channel (map the mouse and KB
to it) use the connected AFP remote
control push buttons.
©2019 All rights reserved. HSL logo and product names are trademarks or service trademarks of HighSecLabs Ltd (HSL).
All other marks are the property of their respective owners. Images for demonstration purposes only.
keyboard shortcut.
•
Scale – one channel in presented on
two thirds of the screen with rest of
the channels on it s right and under it.
To enter this mode, use the: "L CTRL |
L CTRL | s" kb short cut.
The HSL KVM Combiner also supports a second
display that can be used in clone or extend
modes.
To change between display modes, use the
following keyboard shortcuts:
8 Ports Quad Layout
Single/Clone
16 Ports Quad Layout Extended Display mode 8 - 8:
•
As a secondary switching method, the user
can use CNS (curser navigation switching).
Cursor navigation switching is enabled by
default and requires the user to drag the
mouse while pressing and holding the left
CTRL key.
SC82PH-4 SC162PH-4
•
L CTRL | L CTRL |F11| s | 0 – single
display (default)
•
L CTRL | L CTRL | F11| s| 1 – clone
display
•
L CTRL | L CTRL |F11|s | 2 – extended
display
Please see below a diagram of each mode of
operation on one and two displays:
8 Ports Quad Extend Display 4-4
16 Ports Scale Layout Single/Clone display
in Extended mode the primary display will show one channel in Full
layout and the secondary in will show the other 15 in Quad
| QUICK INSTALLATION GUIDE
HDC19963 Rev.1.0