- ページ 6

アダプター Dynex DX-WBRDVD1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynex DX-WBRDVD1 15 ページ。 Lecteur sans fil de disques blu-ray
Dynex DX-WBRDVD1 にも： クイック・セットアップ・マニュアル (2 ページ), マニュアル (6 ページ), パンフレット＆スペック (1 ページ), (重要なお知らせ (17 ページ), (クイック・インストール・ガイド (2 ページ), (重要なお知らせ (17 ページ), (フランス語) ラピッド・インストール・マニュアル (2 ページ), (フランス語）パンフレット (1 ページ)

ページを印刷する
Dynex DX-WBRDVD1 ユーザーマニュアル
6
Problem
When reading a disc,
the disc tray opens
Audio or video pause
during playback
The player is on and
the logo and menu
appear, but there is no
image from the disc
The player freezes
when reading a disc

TV screen and video

Problem
Video does not appear
on the TV screen or
the picture is
distorted
Video is not output in
high definition
The 4:3 aspect ratio
picture expands left
and right or the
picture size is
incorrect
• Make sure that the disc is not dirty.
• The disc may be incompatible with your player. Try another disc.
• Reset your player. For instructions, see "Resetting your player" on page 4.
• Make sure that the disc is not dirty.
• Reset your player. For instructions, see "Resetting your player" on page 4.
• Make sure that the disc is not dirty.
• Reset your player. For instructions, see "Resetting your player" on page 4.
• Reset your player. For instructions, see "Resetting your player" on page 4.
When you see "loading" on the screen, press
tray and remove the disc. Clean the disc. (For instructions, see the User Guide),
then try the disc again.
• If your player freezes again, the disc may contain some content that is not
compatible with your player. Do no try playing the disc with your player.
• Make sure the firmware is up to date. See "Upgrading your player's firmware"
in the User Guide.
• Make sure that the TV is connected to the correct jacks on the back of your
player.
• Make sure that the TV is set to the correct video input source.
• The TV may be in screen saver mode. Check the documentation that came with
the TV for instructions about "waking" your TV.
• Reset your player. For instructions, see "Resetting your player" on page 4.
• High definition video cannot be output through the VIDEO OUT jack. You must
connect the TV to your player using the HDMI jack.
• Make sure that the correct HDMI or component video resolution has been
selected in the Setup menu. See "Selecting the video output resolution" in the
User Guide.
• Use the TV to change the aspect ratio. See the documentation that came with
the TV.
• When using a component video cable, set TV Aspect to 4:3 Pan & Scan. See
"Selecting the TV aspect ratio" in the User Guide.
DX-WBRDVD1/DX-WBRDVD1-CA
Solution
(open/close) to open the disc
Solution