- ページ 3
TVマウント GALTRONICS 62-20-09のPDF 取付方法をオンラインで閲覧またはダウンロードできます。GALTRONICS 62-20-09 4 ページ。 Outdoor das antennas
ページを印刷するBaylin TechnOlogies Company
A.
Attach support bracket to pole
Drill required hole (Ø 1.1") through the
wooden pole (see drawing).
Attach the support bracket to the
wooden pole.
Our recommendation:
Use 1" threaded rods and corresponding 1"
plain washer, spring washers and 1" Nut as shown
in the drawings.
Tighten with a torque of 150Nm (1328 In*Lbs).
Choose threaded rod length according to
Table 1.1.
Table 1.1 - Threaded rod length
Pole diameter:
Threaded rod length:
B.
Assemble right bracket stopper plates and left bracket (Clamping brackets)
Use 7/16" fasteners to attach the support bracket,
stopper plates and left brackets without tightening (see details).
For a pole with diameter between 9" - 12", position the interlock
tabs of the stopper plates towards the support
bracket (see picture detail on the left).
For 6" - 9" pole diameters position, the interlock tabs
away from the support backet.
Tightening hardware to the final position
will be done after placing the antenna
on the pole!
Proprietary Information. All rights reserved. Galtronics reserves the right to modify or amend any antenna or specifi cation without prior notice.
Model No: 62-20-09 | Mounting instructions outdoor DAS antennas
ASSEMBLY INSTRUCTIONS
6"
7"
(152mm)
(177mm)
9"
10"
(228mm)
(254mm)
7/16" Nut
7/16" Plain and
Spring Washer
Copyright © 2016 – Galtronics Corporation Ltd.
w w w . g a l t r o n i c s . c o m
8"
9"
10"
(203mm)
(228mm)
(254mm)
11"
13"
12"
(279mm)
(330mm)
(305mm)
7/16" Plain Washer
page 3 of 4
1.57" (40mm)
6.9" (175mm)
12"
11"
(305mm)
(279mm)
15"
14"
(381mm)
(255mm)
1
7/16" X 1
/ 2 "
1
7/16" X 1
/ 2 "