- ページ 7

テレビ Dynex DX-LCDTV19のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynex DX-LCDTV19 15 ページ。 19" lcd tv

ページを印刷する

07-398_DX-LCDTV19.fm Page 7 Tuesday, August 14, 2007 11:33 AM

Using your LCD TV

Connecting a computer

To connect a computer:

1 Make sure that your LCD TV and computer are turned off.

2 Connect a VGA cable to the VGA port on the back of the computer

and to the VGA IN jack on the back of your LCD TV. Make sure that

you tighten the screws on the ends of the VGA cable.

3 Connect a computer audio cable to the left and right audio output

jacks on the computer and to the PC AUDIO IN jack on the back of

your LCD TV.

4 Turn on the computer and your LCD TV, then press INPUT to select

VGA.

Notes: If the picture quality is not good:

Adjust the brightness and contrast.

Change the PC's video resolution.

Change the refresh rate for the PC's video card. If you cannot change the

refresh rate for the video card, you may need to replace the video card.

Using your LCD TV

Turning your LCD TV on and off

To turn your LCD TV on and off:

1 Plug the power cord into a power outlet. The LED on the front of

your LCD TV lights red.

2 Press . The LED lights green.

Adjusting the volume

To adjust the volume:

• Press VOL+ or VOL– to increase or decrease the volume. A

number appears on the screen to indicate the volume level.

• Press MUTE to mute the sound. Press MUTE or VOL+ to restore

the sound.

Selecting the video mode

To select the video mode:

• Press INPUT one or more times to select the video mode you

want. You can select TV, Composite, S-Video, VGA,

Component, or HDMI.

Selecting the TV signal source

To select the TV signal source:

1 Press MENU, then press CH+ or CH– one or more times until the

following menu opens.

2 Press VOL+ or ENTER, then press CH+ or CH– one or more times

to select Tuning Band.

3 Press VOL+ or ENTER to select the TV signal source. You can select

Cable Auto, Air, Cable, Cable HRC, or Cable IRC. If you use

satellite TV, select Air or Cable depending on the type of satellite

TV signal.

Memorizing channels

To select channels with the CH buttons, your LCD TV needs to memorize

channels. When your LCD TV memorizes channels, it scans for channels

with signals, then stores the channel information into memory.

To memorize channels:

1 Press MENU, then press CH+ or CH– one or more times until the

following menu opens.

2 Press VOL+ or ENTER, then press CH+ or CH– one or more times

to select Auto Ch Search.

3 Press VOL+ or ENTER to start scanning for channels. Your LCD TV

searches for channels that have a signal. Any channel that has no

signal or a poor signal are not saved. During the search, the

following appears.

Your LCD TV scans for analog channels, then scans again for digital

channels. When the search is complete, the first channel appears

on the screen.

Adding channels to the channel list

You can add channels that were not found in a previous scan for

channels.

For example, if your LCD TV found channels 1 through 20 and you select

the Add On Ch Search option, your LCD TV scans for channels starting

at 21.

To add channels to the channel list:

1 Press MENU, then press CH+ or CH– one or more times until the

following menu opens.

2 Press VOL+ or ENTER, then press CH+ or CH– one or more times

to select Add On Ch Search.