- ページ 7

ウォーター・ディスペンサー Coral 735のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Coral 735 8 ページ。 Ion exchange water softener

Close the stop cock again and then open the inlet and outlet valves to the softener. Press and

hold the regenerate button (4) you should hear the cam rotate and the following display will

appear, when the cycle indicator shows C1 slowly open the stop cock about a quarter of the

way, this will purge the air from the system. When all of the air has been purged from the

Advance the regeneration cycle to the (Refill) position C8 by pressing the set button and the

up arrow! Wait until the cam stops before repeating the operation and continue to do this until

you reach C8. When in C8 this will direct water down through the regenerant line to purge

the air; when all the air bubbles have gone and the glass chamber is full, press the set button

and up arrow to move the cycle onto C0 service position.

Finally turn on a tap after the softener until the water runs clear.

Your softener is now ready to supply your property with soft water. Please bear in mind that

it may take some time for soft water to reach all outlets in your home.

It is advised that you instigate a delayed regeneration for the first night (see below)

Manual Regeneration.

This softener can perform two different types of manual regeneration either immediate or

delayed.

Press and release the regeneration button once. The regen symbol will appear and flash on the

display. A single regeneration will start at 2am (preset regen time) if you wish to cancel this

delayed regen simply press the regeneration button again and the symbol will disappear from

the display.

To perform an immediate regeneration press and hold the regen button for 5 seconds until the

cam starts to turn and the egg timer shows.

Rear of control panel

Commissioning the Softener

system (water will begin to run steadily from the drain) open the water

supply fully, this will purge the final air from the system.

- 7 -