- ページ 2

ウォーター・ディスペンサー Coral 935のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Coral 935 8 ページ。 Ion exchange water softener

Thank you for purchasing this Softener. We are sure that it will provide you with

trouble free service for many years to come. Please use the following pages to assist you

in the installation and set up of your new Softener.

Planning Your Installation.

Please observe the regulations concerning the installation of your water softener. For

guidance check out the water regulations advisory service web site (www.wras.co.uk) Check

that you only have one rising main, that you have allowed space for access to the unit for

possible future maintenance and salt replenishment. Check the water pressure; locate the

rising main (stop cock) a drain facility and a power supply.

Unless you are replacing an existing water softener, this installation will require you to carry

out plumbing work and may require an electrical outlet to be fitted near the softener. You

should only attempt this if you have the necessary skills.

Positioning the Softener.

Where possible the softener should be placed close to the rising main. Take care to allow hard

water take off points for a drinking water facility and /or an outside tap. The distance between

the drain and the Softener should be as short as possible. Ensure that both the drain and

overflow will not freeze or reach a temperature above 40°C. If putting the Softener within a

cupboard ensure that the base is adequately supported. If the Softener is being installed within

your loft etc it is recommended to house the Softener within a tank capable of storing at least

100 Litres with an overflow fitted. The overflow on the tank should be below the Softener

overflow and be a minimum of ¾" in size.

A single Check Valve.

A suitable check valve should be fitted. This will usually be in the installation kit that can be

ordered separately.

Before you start the installation make sure that you

have all the necessary fittings. The purchase of one

of our standard installation kits will normally ensure

that you have everything that you need for a typical

installation

It is important that a pressure test is carried out. High

and low water pressure can result in either damage to

or failure of the Softener. Although the Softener is

tested to a pressure of 8 bar (120psi), we recommend

the fitting of a pressure limiter should your pressure

exceed 5 bar (70 psi). The minimum working

pressure is 1.4 bar (20 psi)

Before starting the installation of the valves ensure that the stop cock is in the closed

position.

- 2 -