- ページ 2

配管製品 Galvin Engineering 32728のPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。Galvin Engineering 32728 4 ページ。

Product Installation Guidelines

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in

accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply

conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions

shall void the product warranty and may affect the performance of the product.

Note: (Illustrations are for representation of installation only and is not limited for use to these components)

1. Remove Handle

−

Prior to installation turn off the water supply.

−

Remove the handle assembly. To prevent

damage, carefully pry off plastic indicator from

the handle. (Use a small flat bladed screwdriver

if necessary).

3. Refit new head part

Refit new head part into tap body.

Note: do not tighten cartridge using the handle

as this will result in damage to the cartridge

2. Replace spindle assembly

−

New head part

New ceramic head

4. Reassemble Handle

Unscrew the head part from the threaded sleeve

using a 17mm spanner.

Check seat inside tap body for pitting or damage.

Re-seat if necessary

Refit adaptor and reassemble handle by reversing

step 1.

When installation is complete, slowly open water

supply and inspect for leaks.

Version 1, 4 October 2022, Page 2 of 4