- ページ 5
コントローラー AGS Merlin 1000SiのPDF ユーザー・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。AGS Merlin 1000Si 9 ページ。 Gas safety products, gas utility controller
AGS Merlin 1000Si にも： ユーザー・インストール・マニュアル (7 ページ), インストレーション＆オペレーションマニュアル (16 ページ), ユーザーマニュアル (12 ページ)
ページを印刷する
Merlin 1000Si
Gas Utility Controller
2.11
INTERNAL BUZZER
Operates at 65dB measured 30cm from closed panel.
2.12
PANEL TIMEOUT FACILITY
The Merlin 1000Si has a built-in Auto-shut down feature and it will turn itself off after a
predefined time. Auto-shut down timeout is selectable.
There are two Dip-Switches located on the inside facia of the system labelled [Time1] and
[Time2]. The gas supply will be cut off at desired time-out.
To select required timeout – configure Dip Switches as follows;
2 HOURS (FACTORY SET)
Time1 Off / Time2 Off
4 HOURS
Time1 On / Time2 Off
8 HOURS
Time1 Off / Time2 On
NO TIMEOUT
Time1 On / Time2 On (auto-shut down disabled)
OPERATION
3
3.1
SYSTEM ON & OFF
1)
Turn off all open appliances.
2)
Turn the key switch to on position.
3)
To turn the system off, turn the key switch to off position.
3.2
LED STATUS
POWER
When the system is connected to mains supply, the Red LED of the AGS Logo located in the
bottom right corner of the panel will illuminate.
When no power is present, this LED will not light up.
RED = OK
OFF = No power to 1000Si, a loose wire/ribbon connection or the fuse may not be intact.
GAS ON
When the key switch is turned on, the gas valve will open and the GAS ON LED will illuminate.
GREEN = Gas On
OFF = Gas Off
TIMEOUT
Under normal working conditions this LED is off. This LED will illuminate upon auto-shut down
OFF = OK
AMBER = auto-shut down
Rev: 04 Date: 22-10-18
User & Installation Manual
5