- ページ 14

コントローラー AGS Parksafe Control PanelのPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。AGS Parksafe Control Panel 16 ページ。 Ventilation control panel
AGS Parksafe Control Panel にも：インストレーション＆オペレーションマニュアル (16 ページ), インストレーションオペレーション＆メンテナンス (16 ページ), インストレーション、オペレーション＆メンテナンスマニュアル (20 ページ)

Installation & Operation Manual

Bump Testing

What is Bump Testing?

Bump testing is a term used for checking a gas detector is functioning correctly by exposing it to

the target gas. A known concentration of the target gas is applied to the device to trigger an

alarm condition and ascertain the detector is working safely.

Why is it Important?

A detector may visually appear in good order, but its sensitivity can be inhibited by external factors

such as, dust; humidity; temperature fluctuations; cleaning products; contaminants or sensor drift

(ageing). All can cause a decline in sensitivity and eventual failure.

The aim of the bump test is to make sure a gas detector is working at its optimum by briefly

exposing the unit to a known concentration of the target gas. The reading (if displayed) is

compared to the actual content of gas present, as stated on the test gas cylinder and if the

detector goes into alarm within an acceptable range of the actual concentration, usually within

10%, then it is working safely.

If the bump test results are not within the acceptable range, the gas detector must not be used

until a full calibration has been conducted.

Bump testing has a number of benefits for the end user:



Peace of mind that the system does actually detect the gas in question.



Allows the site to practice safe operations in a similar manner to the fire system.



Early indication of any issues.

How Often?

Regular bump tests are important to make sure the detector is able to detect a release of gas as

early as possible. A bump test usually takes seconds (gas type dependant) and is often completed

alongside a scheduled fire alarm test, however the frequency should be determined following a risk

assessment by the end user.

Current standards recommend that for new installations - it may be prudent to carry out a bump

test frequently, following a successful initial period and as confidence grows in the installation

concerned, the frequency could be reduced.

Remember, bump testing does not remove the need to have gas detectors inspected, calibrated

and serviced periodically by a trained engineer.

employ the services of a specialist company.

For more information on this, contact us.

AGS Parksafe Panel - IOM Iss: 6 10-20

You should not attempt this yourself and should

Parksafe