- ページ 2

配管製品 Galvin Specialised Ezy-Wash TF83HJSのPDF 製品インストール・マニュアリンをオンラインで閲覧またはダウンロードできます。Galvin Specialised Ezy-Wash TF83HJS 5 ページ。 Pre-rinse tapware

PRE-INSTALLATION

Body:



If the mounting holes do not already exist, mark

out and drill the holes in the bench, as shown.



This model is a dual inlet unit requiring a hole

diameters of 23mm - 26mm, 205mm apart. Ensure

70mm minimum between wall and hole center as

shown "A".



Maximum bench thickness is 55mm.

Wall Bracket:



Mark out the three (3) holes for mounting the wall

bracket assembly at a height of between 420mm

min - 510mm max directly up from the bench. Cut

out or drill as shown in the image. (Supplied

fasteners may not be suitable for the mounting

surface. If this is the case, suitable fasteners will

need to be sourced by the installer)

Note: We recommend the wall bracket is installed

at the maximum of 510mm. The wall bracket can be

mounted lower at a height of up to 90mm below the

circlip. However, the further it is mounted away

from the circlip, the more the stability of the unit is

compromised.

TF83HJS – Assembly

Version 1, 11 July 2017, Page 2 of 5

TF83HJP - Assembly