- ページ 3

計測機器 Dynisco PG542のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dynisco PG542 11 ページ。 Melt pressure gauges

DYNISCO PG500 Series

1. INTRODUCTION

The Dynisco PG540/PG550 Series pressure gauges are highly

engineered, electronic devices. With proper installation and handling

these units will provide years of care-free service.

The tip of the gauge consists of a stainless steel diaphragm. Care must

be taken to protect the diaphragm from severe abrasion, dents and

gouges. During storage the protective cap supplied with the unit

should be left in place.

1.1

The gauge probe is machined to tight dimensional tolerances. To avoid

damage on installation, the mounting hole should be carefully

machined and checked for the correct dimensions.

A set of mounting hole machining tools is available (P/N 200925) to

assist in preparation of the mounting hole.

The mounting hole should conform to the recommended dimensions

shown in Figure 2, below.

Fig. 2

Gauge Probe Mounting Hole

1 1 1 1 1