- ページ 5

シャワーキャビン Coram Showers OFFSET QUADRANTのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Coram Showers OFFSET QUADRANT 9 ページ。
Coram Showers OFFSET QUADRANT にも：マニュアル (8 ページ)

ページを印刷する

Check the door frame is vertical and is centrally positioned between the wall channels.

From inside the enclosure, in the 6 positions shown, drill through the wall channels into the fixed panels.

Important: The top holes MUST be 18mm down from the top. Drill using a 3mm drill bit.

Fix using 6 x 10mm screws and screw caps.

Inside of

fixed panel

PN50490

a: Attach 2 x glass clamps to each of the horizontal rails (at edge of glass) using 10mm screws, tighten by hand only - do not

overtighten. Push fit glass clamp covers.

b: Select the short vertical seals (PN40350), fit the seals to both fixed panels.

Important: Seals must sit tight against glass clamps (top and bottom).

Important: Seal 'flippers' must be on inside of the enclosure. Note: Wetting the glass with water will help fit the seals.

From inside

10mm

PN50488

PN40350

18mm

ø 3

10mm

Inside of

fixed panel