- ページ 4
室内装飾品 Coram Showers 1000 Door XのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Coram Showers 1000 Door X 8 ページ。 Sliding door
ページを印刷する4
a
=
100mm max
a: Drill holes in both wall channels (PN10675) at points shown using a 4.5mm drill bit, through the middle and in the groove.
b: Ensure the shower tray is level in all directions.
IMPORTANT: Clean the tray and seal the gap between the tray surface and tiles. It is important that the tray is sealed right up to
the tray edge so that the bottom of the wall channel is sealed. Failure to do this will cause water to leak under the wall channel
and between the tray and tiles, resulting in damp patches on the wall and under the tray.
5
Place wall channels on tray ensuring they are vertical and
a minimum of 3mm back from the front of the tray.
Place masking tape against the wall before marking the
drill hole positions. This will prevent the drill bit slipping.
Drill 6.5mm holes, 30mm deep and insert wall plugs.
4
=
=
ø 4.5
mm
3mm
min
ø 6.5
mm
b
100mm max
6
b
a: Choose the opening side for the door (turn over if necessary).
b: Apply sealant to back of wall channels.
Place wall channels onto door.
a
Fixed
panel
Outside
Fixed
panel