- ページ 5

スクーター Hikerboy City RiderのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hikerboy City Rider 11 ページ。

Press Turn on/off and Mode buttons together to enter settings. With Mode button you can cycle

through functions P0 – P9.

P0 – Wheel Diameter, Press the On / Off button to display the values, use Mode to increase the value

by 1, use the On / Off button to decrease the value by 1. After a few seconds of inactivity, the function

switches.

P1 – Undervoltage, Press the On / Off button to display the values, if the number 315 is displayed,

undervoltage is 31.5 volts. Use Mode to increase the value by 0.5, use the On / Off button to decrease

the value by 0.5. After a few seconds of inactivity, the function switches.

P2 – number of poles, Press the On / Off button to display the values, use Mode to increase the value

by 1, use the On / Off button to decrease the value by 1. After a few seconds of inactivity, the function

switches.

P3 – measuring the speed signal, press the on / off button to display the values, 0 means the motor

gives a speed signal (original value), 1 means the signal is external.

P4 – speed unit. Press the On / Off button to display values, 0 km / h, 1 mile / h.

P5 – start-up assistance, 0 start without reflection, 1 start with reflection. start off with reflection. PAS

is displayed.

P6 – cruise control, 0 off, 1 on.

P7 – start, 0 slow, 1 fast

P8 – speed limit

P9 – ABS

BRAKES

The scooter has both front and rear brakes. The rear warning light comes on when braking. High

speed or wet roads can affect the braking distance.

The breaking mechanism heats up when useed. Therefore, always fully release it after each braking.

For the same reasons, it is also not advisable to touch the braking mechanism immediately after

stopping.

12 months warranty for battery life – we guarantee that battery's nominal capacity does not fall

below 70% of its total capacity within 6 months of the product's sale.