- ページ 4

バスルーム設備 Jacuzzi 0577330CPのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Jacuzzi 0577330CP 5 ページ。

ページを印刷する

ASSEMBLY INSTRUCTIONS

Connect the flexible supply lines (1) to the water

supplies (2).

CARE AND MAINTENANCE

•

and void your warranty.

TROUBLESHOOTING

PROBLEM

There is a leak from under the handle

or there is a leak from aerator when

the faucet is off.

There is a leak from aerator when the

faucet is on.

The aerator has an irregular or

reduced water flow.

Hand shower leaks or has a low flow

pattern.

Flushing debris and checking for water leaks:

Important: After installation is complete, remove the

aerator (2) with the plastic wrench to flush debris from

the water lines. Do not lose the o-ring(1) in the

aerator(2).Turn on the water supply and allow both hot

and cold water to run for at least one minute each.

Remove hand shower and push the diverter pin

button (3) to the bottom position. This will divert water to

the hand shower. Run for at least one minute. This

flushes away any debris that could cause damage or

blockage to internal parts. Check for water leaks. After

flushing, completely shut off water, and reinstall the

aerator (2). The diverter pin button (3) should

auto-reset back into the outward position.

Retighten any water/hose connections if necessary,

but be careful to not overtighten to prevent damage.

Diverter Instructions : To divert water from the faucet spout to the hand shower, push in the diverter pin (3) to the

bottom position.To divert water back to faucet spout, turn the water completely off, and then on again.

The diverter pin (3) will auto-reset back into the outward position. If the diverter pin (3) does not auto-reset back into the

outward position, then gently rotate the diverter pin (3) button left or right while the water is shut off, and it should easily reset

back to the outward position.

CAUTION: While water is running through the hand shower, the diverter will not pull outward to reset to the faucet spout unless

the water is shut off and turned on again. DO NOT FORCIBLY PULL THE DIVERTER PIN (3) OUTWARD WHILE WATER IS

RUNNING. This can cause damage to the diverter pin (3) assembly.

The cartridge is damaged.

The aerator does not fit correctly on

the faucet.

The aerator is dirty.

Hand shower is dirty or damaged.

POSSIBLE CAUSE

CORRECTIVE ACTION

Remove the handle and replace the

cartridge.

1. Remove and reinstall the aerator.

2. Call customer service for a new

aerator and replace it after you receive

the new aerator assembly.

Remove the aerator and clear the

debris.

Remove the hand shower and check

for any debris clogged at the shower

connection, check the hand shower's

spray nozzle for any build up or debris.