- ページ 7

エンクロージャー AFL OptiNID 500のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AFL OptiNID 500 8 ページ。 Optical demarcation closure

ページを印刷する

ADAPTER PLATE INSTALLATION

1. Attach the adapter plate to the mounting bracket by

pressing in the nylatch plungers.

2. Route the pigtail assembly around the splice tray. Use

the routing rings located on the outer edge of the tray to

help manage the cable. (Figure 6)

DISTRIBUTION CABLE

INSTALLATION –

PLUG AND PLAY

Caution: In order to avoid micro bends or fiber

damage do not over-tighten the tie wraps around

the fiber bundles.

1. For application that utilized the Compression Fitting

Kit, determine the appropriate compression fitting for

the application.

2. Install the compression fitting, reference the

Compression Fitting Installation section of this

document.

3. Secure the cable to the retention bracket using a tie

wrap. (Figure 2)

4. Route the distribution cable with one turn around the

splice tray. Use the routing rings located on the outer

edge of the tray to help manage the cable.

5. Use accepted local practice to clean the connector end

face.

6. Plug the distribution cable into the adapter plate as

specified by the local engineering practice.

Repeat steps 3-6 for each additional distribution cable

to be installed. (Figure 7)

Note: A FASTConnect

or FUSEConnect

Splice-On Connector may be

installed onto a non-connectorized distribution

cable. Reference the installation instructions

provided with the FASTConnect Mechanical

Connector or FUSEConnect Splice-On Connector.

The document will include the following:

•

Fiber Preparation

•

Fiber Termination

•

Connector Assembly

Mechanical Connector

INSTALLATION INSTRUCTIONS

OptiNID

Specifications are subject to change without notice.

500 Optical Demarcation Closure

Figure 6

Figure 7