- ページ 2
サーマルカメラ Hikmicro HM-TD2H67T-6/XのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Hikmicro HM-TD2H67T-6/X 9 ページ。 Heat resistant bullet camera
ページを印刷する1 Preparation
Basic Requirement
● All the electronic operation should be strictly compliance
with the electrical safety regulations, fire prevention
regulations and other related regulations in your local region.
● Check the package contents and make sure that the device in
the package is in good condition and all the assembly parts
are included.
● Use the system according to the working environment
requirement.
Checking Installing Environment
● Be sure that there is enough space to install the camera and
accessories.
● Make sure that the wall is strong enough to withstand at
least 8 times the weight of the camera and the mount.
Preparing Cables
● According to the actual network bandwidth, the Cat5 (in 100
M) or Cat6 (100 M above) is needed.
● When the camera uses standard 12 VDC power supply, the
power cable should be American wire gauge 18 or above.
The formula of the cross-section S (mm²) and the maximum
transmission distance L (m) of the bare wire is L=50*S.
● Choose the video cable according to the transmission length.
The video should meet the least demands as: 75Ω resistance;
100% copper core conducting wire; 95% weaving copper
shield.
Heat Resistant Bullet Camera · Quick Start Guide
Preparing Tools
English
Before installation, please prepare the tools needed, such
as the expansion screws, electric hammer, electric drill,
wrench, screwdriver, electroprobe and network cable.
Original Packaging
When you unpack the camera, please keep the original
package properly, in case of returning or repairing the
camera. You can pack the camera with the package.
Note:
The user should be responsible for any damage caused
when transporting with unoriginal package.
2 Appearance Description
2.1 Appearance
Refer to the following figure for the appearance of the camera.
Figure 2-1 Appearance
2.2 Cable Description
The cable interfaces of the camera is shown in Figure 2-2.
1
Table 2-1 Description of Device
No.
Description
1
Camera
2
G1/2 Water/Air Outlet
3
G1/2 Water/Air Inlet
4
G1/4 Air Inlet
5
Mounting Base
6
Cables
Figure 2-2 Cables of Camera