- ページ 8
冷蔵庫 KitchenAid 2000495のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid 2000495 12 ページ。 42” built-in refrigerator
Product support
A
solid soffit or a wood block
is required to prevent the
refrigerator from tipping forward
after it is installed.
Determine what height the
refrigerator will be when it is
installed to fit opening. Determine
the height to the top of the cover at
the final installed height you plan
to use.
Personal injury/Property Damage Hazard
l
Unit is top-heavy and may tip forward
when the doors are opened.
l
A solid soffit or 2" wood block is required
above the refrigerator to prevent tipping
during use.
l
if solid soffit is more than 1 inch above
refrigerator, a wood block must be
installed on the wail not more than
l/4 inch above the refrigerator cover.
Failure to follow these instructions could
resutt in personal injury or property damage,
Your installation
location may vary
from the examples shown. However,
you must support the refrigerator
with a wood block or other adequate
means of support located l/4"
above the cover.
\'I
Locate anti-tip
wood blocks
a maximum
of l/4"
rear wall
When a soffit is not available,
locate wail studs in the refrigerator
opening.
Center one wood block
and use wood screws to attach the
wood block to the wail studs. Make
sure screws engage wail studs a
minimum of 1 -l/2".
Screw the
second wood block to the front of
the first block. The wood blocks
must extend 2 inches beyond the
ends of the cover.
block(s)
Block(s)
must
be long enough
to fully cover
width of cover.
m Important:
Block(s)
must
extend at least 2"
over cover.
above cover)
An&tip
/wood
block(s)
314"
max.
<cover
\
rear wall
if soffit is more than one inch
above cover,
locate wall
studs in the refrigerator opening.
Center one wood block and use
wood screws to attach the wood
block to the wail studs. Make
sure screws engage wall studs a
minimum of 1 -l/2". Screw the
second wood block to the front
of the first block. The wood block(s)
must extend 2 inches beyond the
ends of the cover.
soffit-
(less than 1"
above
cover)
'cover
2
rear wall
if soffit is less than one inch
above cover,
a wood
support
is not needed.
Page 8