- ページ 5

計測機器 AgSense AQUA-TRAC LiteのPDF 配線手順をオンラインで閲覧またはダウンロードできます。AgSense AQUA-TRAC Lite 20 ページ。 2015-18 soil moisture monitoring

Aqua Trac Lite LED Lights Overview

Note: All LED's are off most of the time due to the unit being "asleep" between taking readings.

Below are the descriptions of each LED that comes on during a normal reading, or when the

Check Probe button has been pushed:

PROC LED - This LED blinks at a steady rate to show the processor is working normally.

MODEM LED – This LED blinks when the cell modem in attempting to connect to a cell tower,

and is on steady when the unit has a good cell connection.

RADIO LED – Not used unless unit has a radio installed – This LED blinks when the radio is

attempting to connect to another unit with a radio installed, and is on steady

when the unit has a good radio connection.

GPS LED – This LED blinks when the GPS is attempting to get signal, and is on steady when

good GPS signal is found.

CHR5V LED – This light is on steady when power is applied to the DC Charging Port to charge

the battery

5V/12V LED – This LED is on stead when the unit is taking readings from the sensors.

PROBE LED – This LED blinks when the unit is attempting to read data from the soil moisture

probe, and is on steady when the unit has successfully recieved data from the

soil moisture probe.

SOIL PROBE PWR LED – This LED is on steady when power is turned on to the soil probe.

CELL PWR LED – This LED is on steady when the Cell Modem is turned on to send data.

Page 2