- ページ 7

プールフィルター Jacuzzi 27842.01のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Jacuzzi 27842.01 18 ページ。 Domestic chlorine generating device

ページを印刷する

Section 2a – INSTALLATION

Commander II Model JC5

Control Box

CONTROL BOX converts incoming

AC power to a Low Voltage DC current,

which energizes the Cell(s). Set the

Control Box on a vertical surface away

from excessive exposure to heat and

moisture. Use the template to mark and

drill the (4) mounting holes and insert

the screws, leaving a ¼ in. gap. Hang the

control box on the screws and level.

Remove the cover by following the steps

on page 10 to access the mounting

holes to tighten the screws.

RATINGS:

Input Power: 115 VAC (3.0 AC amps)

230 VAC (1.5 AC amps)

50/60 Hz

Output Power: Cell Power 1 (5.0* DC amps)

Cell Power 2 (6.5* DC amps)

Cell Power 3 (8.0* DC amps)

*Indicates nominal amperage output. The dual axis controller will slightly vary the amps to optimize the power to the cell.

The cell and tri-sensor are located in a Patented Automatic Flow Bypass Manifold Assembly. 3.6m (12ft.) of Cell and Tri-Sensor

cords are provided with the unit. Ensure that the manifold is located within that distance from the control box with enough slack to

allow for removal for service or maintenance.

CAUTION: It is suggested to locate the cell downstream of all other equipment and on the pool return line only to avoid over-

saturation conditions of your spa. For applications other than as recommended, contact the factory.

Main Components

Tri-Sensor Assembly

Union

Flow In

ELECTROLYTIC SUPERCELL

receives Low Voltage DC current from

the Power Circuit Board, which initiates

the electrolytic process. This process

converts ordinary table salt (Sodium

Chloride) to 100% Pure Sodium

Hypochlorite (Chlorine Bleach) or

Bromine (with the addition of Sodium

Bromide), which in turn sanitizes your

pool or spa.

See page 8 for salt requirements.

Maximum Output:Equivalent to 0.54 kg (1.19 lbs) of free available chlorine/day

JC5 CELL @ Cell Power Level 3 (8 amps DC)

Cell Life Expectancy: A minimum of 15,000 ampere/hours

Agency Approvals: NSF, ETL us, ETL c, CE

Cell for Commander II = JC5

Flow Out

TRI-SENSOR ASSEMBLY

ensures that adequate flow

94.5 L/min (25US Gallons/min)

minimum; salt, 2,8 – 3,2 gm/l

(2800–3200 ppm) ideal range; and

water temperatures, above

15.6°C (60°F) are satisfactory to

prevent abusive conditions for the

cell to operate. See page 10 for

instructions to remove and inspect

the tri-sensor assembly.