- ページ 3

屋外ライト Gama Sonic GS-94WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gama Sonic GS-94W 6 ページ。 Solar lamp post

Tools that needed but not supplied with the high post solar lamp set are: a screw

driver, a wrench and an electrical drill that will be used to anchor the lamp base to the

ground.

Solar Light Location

It's important to mount your solar lamp post in a spot where it will receive maximum

sunlight throughout the day. Shadows cast by your home; trees and other structures

will move and lengthen during the day. So please consider this before deciding on a

location.

Assembly Instructions

GS-94L and GS-94S

NOTE: The following steps are for reference only. Consult your local

hardware store for the best installation method for your particular surface.

1. Use the electrical drill to make three holes in concrete floor, which

shall be similar to but smaller than the screws (G). The holes shall be

lined up with the holes of the lamp base (F).

2. Put the fastening screws (G) into the holes with their ends facing up

(Fig. 1-2).

3. Secure the screws to the lamp base using a wrench.

4. Make sure the lamp base (F) is stable before installing Part (D) to the

lamp base by using 3 supplied screws.

5. GS-94L: Then screw part (A) into part (B) and part (B) to Part (D).

(Fig 3).

6. GS-94S: Then screw part (A) into Part (H), part (H) to part (B), part (B)

to part (C), part (C) to part (D). (Fig. 4).

7. Turn the On/Off switch in the lamp head (A) to ON position according

Fig. 4 and 5.

8. Be sure to place your lamp post in a spot where it can receive

maximum sunlight throughout the day. It will turn on automatically at

night.

NOTE: The solar light must be charged for two sunny days for best results.

Fig. 1

Fig. 2

GS-94S

GS-94L