- ページ 2

カーエレクトロニクス Dynojet POWER VISION PV3-1612CのPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。Dynojet POWER VISION PV3-1612C 8 ページ。 For 2017-2023 honda pioneer 500; 2021-2024 honda pioneer 520; 2017-2024 honda pioneer 70; 2016-2021 honda pioneer 1000

ページを印刷する

INTRODUCTION

RETURN

SCROLL

ENTER

HOME/LOG

SCROLL

POWER VISION OVERVIEW—FRONT VIEW

USB CABLE PORT

CONNECT TO COMPUTER

POWER VISION OVERVIEW—SIDE VIEW

INSTALLING THE POWER VISION

DIAGNOSTIC PORT—1000

2 INSTALLATION GUIDE 98200126

DIAGNOSTICS CABLE PORT

CONNECT TO VEHICLE

Thank you for purchasing the Power Vision from Dynojet

Research. The Power Vision is the device to interface

between your computer and vehicle ECU allowing you

to tune your stock ECU to achieve optimal performance

from your vehicle.

Use the buttons to navigate the device menus, make

selections, cycle through the four available gauge

screens, and log data. Connect to the diagnostic port

to flash a tune; use the USB connection to interface

between the Power Vision and your computer.

For state of the art technical support, please visit

dynojet.zendesk.com.

Secure the Power Vision to the vehicle using the supplied

Velcro. Make sure the Power Vision will not interfere with

the operation and steering of the vehicle.

Note: The Power Vision does not need to be mounted

to the vehicle.

Attach the diagnostic cable to the diagnostic port on the

Power Vision and to the diagnostic port on the vehicle.

Pioneer 1000 Models: located under the seat, under a

rubber panel.

Note: Leave the 4-pin CAN connector disconnected.

This connector is only used with the Wideband module

for Honda (P/N WB-PV16-1).

Affix the supplied CARB E.O. label to a conspicuous area.

Next to the original emissions label is a good location.

On many of these models this is on the downtube of the

frame. Make sure to clean the surface before attaching.

E.O LABEL D-619U-21 FOR 500 / 520 / 700

E.O LABEL D-619U-15 FOR 1000

2 HONDA