ページを印刷するAssembly Instructions
3" Pole/Fitter Mount
NOTE: If you are replacing an existing gas/electric
post light, you must consult a certified technician
to properly disconnect and secure the gas/electric
connection.
1. Attach the 3" fitter (C) to the fixture
(B) using the bolt and secure from
inside the fitter (C) using the lock
washer and nut.
2. Place the fitter (C) on top of the 3"
post and secure using the 3 screws
provided.
NOTE: Be sure to not overtighten the set
screws.
Pier Mount
1. Using the pier base (D) as a template,
mark and drill two holes no larger
than the provided anchors.
2. Place the anchors in the holes and
secure the pier base (D) with the
provided screws.
3. Attach the fixture (B) to the pier base
(D) using the bolt and twist the fixture
(B) clockwise until secure.
NOTE: There are specific types of screws for
specific surfaces. If unsure of the appropriate
type of screw to use on your surface, please
consult a professional.
Wall Mount
NOTE: For best results, position your solar
lamp so it is facing south.
1. Using the wall mount (E) as a
template, mark and drill two holes no
larger than the provided anchors.
2. Place the anchors in the holes and
secure to wall mount (E) with
the provided screws.
3. Attach the fixture (B) to
the wall mount (E) using
the bolt and twist the
fixture (B) clockwise
until secure.
page 3
Operation Instructions
1.
Remove the top (A) from the fixture (B) by removing the two
screws under the top (A).
2.
Install the GS Solar LED Bulb by twisting clockwise.
3.
Switch the lamp to the ON position.
4.
Replace the top (A) on the fixture (B) and secure with the
screws removed earlier.
5.
Your lamp will turn on automatically at dusk.
NOTE:
If there is a film covering the solar panel, make sure to remove this by
peeling it off.
Replacement Parts
Replacement Batteries and Bulbs are available at
www.gamasonic.com or via our Toll Free number: +1-800-835-4113
Your Lamp can use the following bulbs:
A50WW10W – included bulb with Warm White LEDs (2700K)
A50BW10W – bulb with Bright White LEDs (6000K)
F30WW05W –Flame bulb with simulated flame LEDs
T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)
Your lamp uses the following battery:
GS36V08