- ページ 3

ランタン Gama Sonic 214801のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Gama Sonic 214801 4 ページ。 Stainless steel bollard solar lamp with ez anchor

ページを印刷する

TOP

RING

ASSEMBLY

BOLLARD

POLE

WARNING: GAMA SONIC

in other electrical sockets. They are low-voltage light

bulbs that are built and designed for our products only!

page 3

Light bulbs are not to be used

Operation and assembly instructions.

1. Remove the Adaptor from the base by

unscrewing the two silver caps from the

bottom of the Bollard Pole (A).

2. Secure the Ring Assembly (B) to the Bollard

Pole (A) using the glass and twisting it

clockwise.

NOTE: If the two parts do not easily fit, try

inserting the glass into the Bollard Pole at an

angle until the glass starts to thread in.

3. Insert the GS Solar LED Bulb into the Top (A)

by screwing it in clockwise.

4. Set the operation switch to one of the

following settings:

High = Brighter light output

Low = Softer light, longer duration.

5. Connect the Top (A) to the Ring Assembly

(B) by twisting clockwise.

6. The Solar light will automatically operate

from dusk to dawn.

Flat surface installation Instruction

1. Using the Adaptor as a template, drill two

holes no larger than the anchors in the

desired mounting location.

2. Insert the anchors in the holes and secure

the Adaptor using the provided screws.

3. Attach the assembled lamp to the Adaptor

and secure using the silver caps.

EZ Anchor installation

1. Insert the Auger bit into the Adaptor and

secure it from the bottom using the four

supplied screws.

2. Place the Turning bar in the hole through

the Auger bit and begin turning the Auger

clockwise in the desired mounting location.

3. Apply downward pressure while turning

clockwise and occasionally check the level in

the Auger so it is vertical.

4. Stop turning once the Ground Stop Ring is

flush with the ground.

5. Remove the turning bar and place the

assembled lamp on the Adaptor.

6. Secure the lamp with the two silver caps.