- ページ 9

錠前 Corbin Russwin Access 800のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Corbin Russwin Access 800 17 ページ。 Cl33800 tcac2 series cylindrical lockset
Corbin Russwin Access 800 にも：取付説明書 (16 ページ), プログラミング指導 (16 ページ)

ページを印刷する

Installation of Inside Escutcheon (continued)

CAUTION: Do not allow lockbody harness wires to enter cylinder hole in lockbody. Wire

damage and/or malfunction of the lock may occur.

1. Turn inside lever to the horizontal position and rotate the turnpiece to the vertical position. Slide

onto spindle halfway. With inside escutcheon resting on spindle, be certain that all keypad ribbon

cable will remain inside ribbon cable hole, and that ground wire will not get pinched once

escutcheon is mounted. Escutcheon will not fit flush on door otherwise.

2. Insert 3 #10-24 screws through inside escutcheon and thread loosely into outside escutcheon. Check

operation of both inside and outside levers and make sure the turnpiece and key still operate the

latch and deadbolt correctly. If lock function is satisfactory, fully tighten the bottom two screws.

Check operation of both levers again. If levers move freely, tighten top screw. If levers do not move

freely, loosen bottom screws and realign the escutcheons until proper operation is obtained.

Lockbody harness - Feed excess

wire back into the mortise of the

door between the door cavity and

lockbody. Do not feed excess

wires into the cylinder hole of

the lock.

Installation Instructions

Inside

of door