ページを印刷する
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 18.92lbs (8.6kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Installation Steps :
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
Fig.3
Lock Pin
Hanger Pin
Remove the Lock Pin and take off
the Hanger Pin.
Fig.6
Lock Pin
Collar Screw
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it locks into position.
Wood Member
Ceiling Joist
(2" x 4" Approx.)
Ceiling
Hanger Bracket
Tighten the hanger bracket to the outlet box with two mounting screws.(Make
sure the outlet box is securely installed so that it will be able to support at
least the fan weight.) Attach the safety cable hook to the ceiling with the dry
wall screw and washer, and make sure the safety cable hook is covered by the
fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE
FOR FAN SUPPORT"!
Fig.4
Downrod Stand
Cover
Downrod
.4
Collar
Slide canopy and downrod stand
cover onto downrod, as shown;
Then thread motor wires through
downrod.
Fig.7
Slot
Chip
PAGE: 5 / 8
Wood Member
(2" x 4" Approx.)
Ceiling
Washer
Junction Box
Dry Wall Screw
Fig.2.
Fig.5.
Fig.5
Motor Wire
Canopy
Hanger Pin
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Hang fan on hanger bracket, and
Hanger
rotate the downrod until the chip on
Bracket
the hanger bracket snaps into the slot
on the hanger ball.
Ceiling Joist
Junction Box
Hanger Bracket
Safety Cable Hook
Downrod
Collar
F
F
A
A
N
N
C
C
140116
O
O