レシーバー Jade GIGALINK GLR43302のPDF セットアップ方法をオンラインで閲覧またはダウンロードできます。Jade GIGALINK GLR43302 2 ページ。

ページを印刷する

GLR2702/GLR43302 GIGALINK™ RECEIVER SETUP INSTRUCTIONS

The transmitter/receiver can be single or channelised code programmed.

Single Code Programming

This is used for programming one channel at a time to the transmitter. Single code programming can be

achieved by following the steps below:

Step 1:

Connect power to the GIGALINK™ receiver. Make sure all switches on the mode dipswitch

are off.

Step 2:

Momentarily short the two CC pins on the receiver board. (This sets all the channels to a

random code. If there are transmitters previously programmed, they will have to be re-

programmed when CC pins are shorted.)

Step 3:

Select the receiver channel, to be programmed, by setting the 2-way dip switch. See dip switch

table below.

Dip Switch

Setting

Off

Step 4:

Connect the transmitter to the receiver by inserting the GIGALINK™ cable into the transmitter

and receiver 2.5-mm socket. (This will activate the programming mode and is indicated by the

red light (LED) on the transmitter that must remain "on")

Step 5:

Activate one of the selected channels on the transmitter for approximately one second, LED

should blink twice to confirm code programming and then switch "off".

Step 6:

Disconnect GIGALINK™ cable.

Repeat steps 3 to 6 to program another transmitter channel.

Channelised Code Programming

This is used to program all channels from a multi channel receiver to a multi channel transmitter. Channelised

code programming can be achieved by following the steps below:

Step 1:

Connect power to the GIGALINK™ receiver. Make sure all switches on the mode dipswitch

are off.

Step 2:

Momentarily short the two CC pins on the receiver board. (This sets all the channels to a

random code. If there are transmitters previously programmed, they will have to be re-

programmed when CC pins are shorted.)

Step 3:

Connect the multi channel transmitter to the multi channel receiver by inserting the

GIGALINK™ cable into the transmitter and receiver 2.5-mm socket. (This will activate the

programming mode and is indicated by the red light (LED), on the transmitter that must remain

"on")

Step 4:

Press any two channels simultaneously on the multi channel transmitter for one second, LED

should blink twice to confirm code programming and then switch "off".

Step 5:

Disconnect GIGALINK™ cable.

Repeat steps 3 to 5 to program another multi channel transmitter.

Receiver Channel

(Output Relay)

Off

Receiver Type

GLR2702/GLR43302

ELSEMA

Enter the world of wireless