- ページ 6
クックトップ Frigidaire FEC30S7EC - 30" Smoothtop Electric Cooktop SS TrimのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Frigidaire FEC30S7EC - 30" Smoothtop Electric Cooktop SS Trim 14 ページ。 Wiring diagram (all languages)
Frigidaire FEC30S7EC - 30" Smoothtop Electric Cooktop SS Trim にも： 配線図 (2 ページ)
ページを印刷する
Models with Ceramic Glass Cooktop
Operating Single Radiant Surface Elements (all Ceramic Glass Cooktop models)
Your cooktop is equipped with Single Radiant Surface Elements.
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the desired setting (Figure 1). Turn
the knob to adjust the setting if desired. Start most cooking operations on a higher setting and then
turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat
at each setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
3. When cooking has completed, turn the surface control knob to OFF before removing the cookware.
Note: The Surface Indicator light located under the glass cooktop will come on when the control
knob will be turn on and will continue to glow until the glass cooktop has cooled down to a moderate
level. The light may remain on even though the controls are turned OFF.
Note: See Figure 2 on page 5 for recommended control settings.
Operating the Dual Surface Radiant Element (some Ceramic Glass Cooktop models)
Some models have 1, 2, 3 or 4 Dual Radiant Surface Elements. Heat power levels
are adjusted by a special control knob that has a dual set of graduations; for small
utensils use the small graduations (Figure 2); the inner surface only will be heating
(Figure 4). For larger utensil use the larger graduations (Figure 3); the whole
surface will be heating (Figure 5).
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See Figure 2) for smaller
cookware or clockwise (See Figure 3) for larger cookware.
3. Turn the knob to adjust the setting if needed. Start most cooking operations
on a higher setting and then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat at each setting. A glowing
red surface heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface control knob to OFF before
removing the cookware. Note: The Surface Indicator light located under the
ceramic glass will come on when the control knob will be turn on and will
continue to glow until the glass cooktop has cooled down to a moderate level.
The light may remain on even though the controls are turned OFF.
Note: See Figure 2 on page 5 for recommended control settings.
Radiant surface elements may appear to have cooled after they have been turned off. The Hot surface indicator
light will come on and will continue to glow until the glass cooktop has cooled down to a moderate level. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Setting Surface Controls
(some models)
6
Control knob shown
is typical only.
Control knob shown is typical only.
Figure 2
Figure 4
Figure 1
Figure 3
Figure 5