ページを印刷するFig.5
Mounting Plate
There are four grommets attached in
the hardware package. Insert the
grommets into the holes in the mounting
bar. Then install the mounting bar onto
the mounting plate using lock nuts and
washers.
Blade Screw
Washer
Blade Holder
Fig.7
Attach the Blade to the Blade Holder
with Washers and Blade Screws.
Repeat for remaining fan blades.
Fig.10
Lamp Plate
Connect the small wire harness from
lamp cover to the small wire harness
from lamp plate. Connect the large
wire harness from fan fixture to the
large wire harness from lamp plate.
Make sure all connections are secure.
Fig.6
Mounting Bar
Grommet
Washer
Lock Nut
Motor
Slide the Housing up over the Motor. Align the Pegs on the Mounting Plate with
the Slots on the Housing
secure.
Blade
Secure Blade Holders to the Motor
with Motor Screws and washers.
Fig.11
Lamp Cover
Small Washer
Bolt Nut
Line up 3 holes in lamp plate with 3
screws on lamp cover, and secure with
small washers and bolt nuts.
Mounting Plate
Hook
Housing
(Fig.6-a)
. Rotate the Housing clockwise to tightly
Fig.8
Blade Holder
Motor Screw
Lamp Plate Screw
PAGE: 2 / 4
Fig.6-a
Fig.6-b
Mounting Plate
Peg
Peg
Slot
Housing
Motor
Lamp Cover
Thread the fixture wire through lamp
cover and secure it with set screws.
Fig.12
Thread the center pull chain through
the stem, making sure the hex nut side
is pointing up. Screw the stem into the
coupling. Adjust the length by moving
the hex nut.
Rotate
Housing
Fig.9
Terminal
Set Screw
Coupling
Stem
090218