- ページ 5

スピーカー Deaf Bonce APOCALYPSE AP-MX80のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Deaf Bonce APOCALYPSE AP-MX80 16 ページ。

M i x e d c o n n e c t i o n o f t h e s p e a k e r s

S e l e c t i o n o f t h e d i a m e t e r o f s p e a k e r c a b l e s

Use the table below to select the desired diameter based on the length and the power consumption.

4 . F I L T E R I N G , R E C O M M E N D E D A M P L I F I E R S E T T I N G S

The correct choice of amplifier, its settings, filtering and enclosure largely influence on the lifespan of your audio system. You

should select an amplifier with a nominal power, not exceeding the nominal power of the speakers. Proper coordination of the

head unit (HU) with the amplifier will allow to get a clean, undistorted signal applied to the component to prevent overheating

and voice coil damage. Recommended settings of the amplifier and HU: Volume of HU should not exceed 80%. The amplifier

sensitivity should be set to 50%.

The recommended filter settings:

The high pass filter HPF (the filter that cuts all frequencies below those set for the filter) should be set to 150-250 Hz

(24 dB/Oct), or 250-350 Hz (12 dB/Oct)

The low pass filter LPF (the filter that cuts all frequencies above those set for the filter) should be set to 8-10 kHz (12

dB/Oct)

Recommended amplifiers: AAK-OGO2500.1D, AAK-OGO1500.2D, AAK-180.4, AAK-200.4D, MFC-120.2, MFC-90.4,

MA-150.4, MA-130.4, MA-80.4, MA-50.4.

CAUTION!!! High sound pressure can damage your health!

Please use the common sense when controlling volume!

Voice coil

4 Ohm х 4 MR

Total impedance

4 Ohm