- ページ 2

ラック＆スタンド Gamber Johnson 7160-1157のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Gamber Johnson 7160-1157 2 ページ。 Tablet keyboard mount-fixed position

keyboard

dual lock

strips

Adjusting the keyboard tray position

1. The keyboard tray is shipped in the position shown above. The tray can be

repositioned to the lower position or it can be repositioned forward or

backward 1" by removing the 1/4" mounting hardware on each side of the

tray and relocating the tray to the desired position. Make sure to reuse both

1/4" hex bolts on each side of the tray to secure it in place when done.

Attaching the keyboard to the tray with dual lock

The keyboard can be attached to the tray using (4) 8" to 10" long pieces of

Dual lock faster supplied in hardware bag 7120-0714.

Cut the Dual lock strip into (4) 8" to 10" pieces. Lock the 4 pieces of dual lock

fastener together to make 2 attached strips with the release liners toward the

outside.

Remove the release liner from one side of each attached strip and attach to

the bottom of the keyboard.

With the 2 assembled strips attached to the bottom side of the keyboard,

remove the 2 remaining release liners. Position the keyboard above the

keyboard tray in the desired position and press the keyboard down firmly to

adhere the strips to the keyboard tray.

To remove the keyboard from the tray, hold both sides of the keyboard and

pull away from the tray. The dual lock strips will separate from each other.

To reattach the keyboard to the tray, realign the dual lock strips and press

downward on the keyboard to snap the dual lock strips back together again.

Keyboard tray

1/4" hex bolts & washers

(2 each side)