- ページ 10
エアコン Gree Mini-Floor Console A SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gree Mini-Floor Console A Series 18 ページ。
ページを印刷する
OPERATION OF REMOTE CONTROLLER (Continued)
OPERATION OF REMOTE CONTROLLER (Continued)
Introduction for buttons on remote
controller
NOTE
• This is a general use remote controller. It could be
used with multiple GREE multi-functional models. If
a function is not available on your model, pressing
the button will have no effect.
• After turning the power on, the unit will give out a
sound. When the power indicator light is on " ", you
can operate the system using the remote controller.
• The signal icon " " will blink once and emit a "di"
sound when the ON button is pushed. This indicates
a signal has been sent to the unit to turn on.
Press this button to turn on the unit. Press this button
again to turn off the unit.
Press this button to select your required operation
mode.
• When selecting the auto mode, the unit will operate
automatically according to the factory settings. Press
"FAN" button to adjust fan speed. Press " " / " "
button to adjust the fan blowing angle.
• After selecting "COOL", the unit will operate under
cool mode. Press the " " or " " button to adjust the
set temperature. Press "FAN" button to adjust fan
speed. Press " " / " " button to adjust fan blowing
angle.
• When selecting DRY mode, the air conditioner
operates at low speed under DRY mode. Under DRY
mode, fan speed can't be adjusted. Press " " / " "
button to adjust fan blowing angle.
• When selecting "FAN", the unit will operate in a "fan
only" mode (no heating or cooling), and all indicators
will be off. When all indicators are off, press "FAN"
button to adjust fan speed. Press " " / " " button to
adjust fan blowing angle.
MIN I- F LOO R CO N SO L E A S E R I ES OWN E RS M A N UA L - I N D OOR UN I T
• When selecting "HEAT", the air conditioner operates
under heat mode. Press " " or " " button to adjust set
temperature. Press "FAN" button to adjust fan speed.
Press " " / " " button to adjust fan blowing angle.
NOTE
• When selecting the HEAT mode, there will be a 1-5
minute delay to allow the coil to warm up before the
fan blows. This prevents cold air blowing at start up.
• Set temperature range from remote controller:
16-30 °C (61-86°F);
• Under AUTO, temperature can be displayed and
adjusted.
Pressing this button can set fan speed circularly as:
auto (AUTO), low ( ) ,medium ( ), high (
NOTE
• Under AUTO speed, the system will select proper
fan speed automatically according to factory default
setting.
• It's low fan speed under DRY mode.
• X-FAN function: Holding fan speed button for 2s in
COOL or DRY mode, the icon " " is displayed and
the indoor fan will continue operation for a few
minutes to dry the indoor coil, even though you
have turned off the unit. After start-up, X-FAN OFF
is defaulted. X-FAN is not available in AUTO, FAN or
HEAT modes.
This function helps remove moisture on evaporator
of indoor unit after the unit is stopped.
• Having set X-FAN function on: After turning off
the unit by pressing ON/OFF button, indoor fan will
continue running for a few minutes at low speed.
In this period, hold fan speed button for 2s to stop
indoor fan.
Turn off the X-FAN function by pressing the ON/OFF
button.
| 1 0
).