ページを印刷する
Know Your Pool
Before you begin installation it is a good idea to know certain specifications about your pool:
How big is your pool?
How many gallons does it hold?
What is your pump motor's power in watts? (i e 240W)
What size hose does it use? (i e 1¼" dia, 1½" dia or 2¼" dia)
What kind of hose connection does your pool use? (i e threaded/unthreaded)
What location will position the heater for maximum sun exposure?
Solar Heater Location
Your solar heater needs to be located on a hard, level surface free of sharp objects which could punture the heater You will need to
position the heater lower than the pool's water level and at a safe distance away from the pool (see Section 1, Safety Warnings) For
best results and long life of the product, placing a tarp on the ground beneath the heater is recommended
• The unit(s) should never be placed on the roof of any structure, or more than 60" above the water level of the pool
• The unit should be positioned in an area which receives as much direct sunlight as possible
NOTE: The solar heater is to be installed between the filter and the pool water inlet, AFTER the water is
filtered. The heater must come after the filter to prevent pressure buildup in the tubing.
IMPORTANT: If you are using a chlorine generator OR an in line chlorinator, it must be connected in-line
Before loosening any threaded connections on your filter, pump or pool, be sure that the suction and pressure hoses on the filter are closed
or blocked to prevent water flow. Do not attempt to move or reposition the heater while the pump is on and the heater is pressurized.
3.
PARTS LIST/REFERENCE
Primary Components
Main Unit (1)
Hose Connector With O-Ring (2)
Hose (1)
Note: Some parts may be pre-installed at the factory. Parts not shown to scale.
following the solar heater to prevent damage to the heater.
CAUTION
Cover (1) (XB2 Item 4527 Only)
Flat Gasket (2)
Owner's Manual
Hose Clamp (2)
5
INTEX® Adapter (2)
Only used with 2¼" diameter
threaded hoses
SAVE THESE INSTRUCTIONS