- ページ 5

おもちゃ Deagostini Model Space HUMMER H1のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Deagostini Model Space HUMMER H1 18 ページ。

HUMMER H1: STEP BY STEP

7 7

Next, fit and tighten the second 3 × 8mm

self-tapping screw into the adjacent hole.

Assembled parts

This stage is complete. Be sure to keep all

the unused parts in a plastic bag safely,

marked for reference.

Sealing the radio box

The radio box fitted inside your RC Hummer H1 is different to that

of most radio-controlled cars. Due the heavier, off-road nature

of its use, your Hummer's radio box requires a considerable

amount of protection. As such , the radio box is designed and

fitted in such a way that it is able to operate under even the

most ambitious driver. Firstly, the radio box itself is made of thick

impact-resistant plastic, moulded to provide excellent protection

The joint between the edges of the radio

box's upper and lower sections features

a high step to prevent dust particles or

water entering.

8 8

Place the 3 × 10mm self-tapping screw into

the hole that sits on the joint between the

chassis's main and rear plates. This was the

hole marked in blue in Step 4.

from dust and water. To achieve this, a high step has been

moulded along the edges of the upper and lower box sections

(see photo below left). Then, the box is fitted several millimetres

above the chassis base, rather than on it, so that the box receives

fewer of the vibrations or jolts experienced by the rest of the

chassis, as these can affect the smooth running of the radio

control components within the box.

It is possible to run your Hummer H1

through puddles, as the crucial radio box

is so well sealed and protected.

209

9 9

Fit the remaining 3 × 8mm self-tapping

screws into the last three holes that were

marked in Step 4. Tighten each fully with

a screwdriver.

The chassis and components stripped

of the body casing after driving through

water. It is advised that the model be

cleaned thoroughly after use.

™