テント Core 40034のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Core 40034 2 ページ。 10p straight wall cabin tent
ページを印刷する10P Straight Wall Cabin Tent
14ft x 10ft x 86in
We Recommend...
2 People
Rubber Mallet
Setup Tips
• For a comfortable night's rest, clear your camp area of debris
before setting up your tent.
• When opening for the first time, the rainfly and room divider are
rolled together with the tent body.
• Lay out all of the contents of the bag and assemble all tent
poles before setting up your tent.
• The tent poles are color-coded to match the sleeves and pole joints.
• Push the poles through the sleeves, don't pull.
• Make sure the sleeve fabric is evenly distributed to avoid
catching the pole.
1
Stake Tent
Pull tent out flat and tight
Drive stakes through all webbed loops (fig. 1)
You may need to adjust stakes after setup
2
Insert Black Poles
Push black poles through the black sleeves
Insert one end of each black pole into the ribbed end
of the corner pole joint (fig. 2)
Flex poles into an arch and insert other end of the poles
into the ribbed end of the opposite corner pole joint
fig. 2
3
Insert Gray Pole
Push gray pole through light gray sleeves, placing over
black poles at the center of roof
Insert one end of gray pole into the ribbed end of
the side pole joint
Flex gray pole into an arch and insert other end
into the ribbed end of the opposite side
pole joint
Tie fastener to all three poles at
the intersection (fig. 3)
Level Area
45˚
fig. 1
fig. 3
Pin-and-Ring System
Pin-and-Ring: Pins are inserted into
ends of leg poles.
Webbed Loop: Insert stakes through
these loops to keep the tent secure.
Pole Joints
Color-Coded Pole Connector:
Color-coded to match corresponding
roof poles
Roof Pole Connector: Connects to
steel roof poles
Leg Pole Connector: Leg poles lift
tent roof and connect to
pin-and-ring system
4
Insert Leg Poles
Starting on one end, place the leg poles into the leg pole connector on pole joint (fig. 4)
Insert the pin from the pin-and-ring system into the orange end of the leg pole (fig. 5)
Repeat until all poles are in place, putting the poles with "D" rings in the center
position on tent front and back
Clip plastic hooks from tent to all leg poles (fig. 6)
Extend and stake the ground air vents located at both ends of the tent (fig. 7)
fig. 4
fig. 5
5
Attach Rainfly
Drape rainfly over the tent, aligning CORE® logo above the T-door
Secure S-hooks to the pin-and-ring system at the base of the tent (fig. 8)
Attach rainfly to leg poles using hook-and-loop fasteners
located on the underside of the rainfly (fig. 9)
Extend attached guylines and stake
fig. 8
Model #40034
Contents & Repair Parts
Tent
Rainfly (90958)
Light Gray Pole x 1 (90957)
Middle Pole with "D" Ring x 4 (90099)
Corner Leg Pole x 4 (90098)
Room Divider
(90960)
Stakes x 16
(90014)
Side Pole
Joint x 6
(90102)
Carry Bag
(90961)
fig. 6
45˚
fig. 7
fig. 9