- ページ 9

プールフィルター Game Group SandPRO 4516のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Game Group SandPRO 4516 18 ページ。 25 pool filter system

ページを印刷する

5. Securing the filter assembly.

a. Install the main tank seal around the bottom of the 7 position multi-port valve.

See Figure 6.

NOTE: Apply a good amount of silicone grease or pool lube around the seal

before installing it onto the valve. This will allow for an easier installation and

b. Install the valve onto the filter tank using the clamp ring and securing it with the included

5mm hex key. Make sure that the top of the manifold assembly fits into the bottom of the

valve. Tighten clamp until there is less than a

c. Install all 3 threaded connectors (with o-rings) onto the valve. See Figure 6.

d. Install the pressure gauge. Do not to over tighten.

See Figure 6.

e. Install the included hose from the pump outlet port to the

filter intake port. Secure with the provided hose clamps.

NOTE: For smaller hoses a rubber reducer may be used.

See Figure 7.

6. Completed Assembly

The basic Filter-to-Pump Assembly should resemble Figure 7.

Ensure ALL hose connections are tight and the hoses

are NOT kinked or bent at severe angles. If the hoses are

leaking, check to make sure ALL of the parts with o-rings

have them attached and are screwed on tightly.

DO NOT over tighten hose clamps (35 in/lb max torque).

provide a better seal.

⁄

" gap between the 2 halves of the clamp.

CAUTION

Completed

Assembly

Hose

Clamp

Pump

Outlet Port

Hose

Clamp

Hose

Connectors

Main Tank Seal

Figure 6

Filter

Intake Port

Figure 7

SAVE THESE INSTRUCTIONS

Hose

Connector

Pressure

Gauge

Clamp Ring

Assembly