2 Getting Started
2.1 Inserting the Memory Card
Insert the memory card with the gold contacts facing the back of the camcorder. Push the
memory card until it clicks into place.
To remove the memory card
Push to eject the memory card out of the slot.
Note:
1. Do not remove or insert the memory card when the camcorder is turned on. This may
damage the memory card.
2. It is recommended to use a 32GB, Class 10 or above micro SD card.
3. Please format the micro SD card prior to the initial use.
4. If the screen shows "Low Speed Card" while recording, it means the writing speed of the
memory card is too slow. Please replace it with a higher-speed memory card.
2.2 Installing in Vehicles
2.2.1 Mount to windshield
1. Attach the bracket to the camcorder. Slide it into the bracket holder.
2. Before installing the bracket, please use alcohol to clean the windshield and suction cup of
the bracket. Wait for dry and press suction-cup on the windshield
3. Hold the base firmly on the windshield and press down the clamp to mount the car holder to
the windshield. Make sure the base is securely locked in place.
2.2.2 Adjust the camcorder position
1. Loose the small screw to swivel the device vertically or horizontally.
2. Then tighten the small screw to make sure the camcorder is securely locked in place.
Page 6 of 16