- ページ 12

ストーブ Dean Forge Dartmoor Baker 5E EcoのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dean Forge Dartmoor Baker 5E Eco 18 ページ。

Installing a Multi-fuel kit in a Dartmoor Baker W5 Eco

To install a multi-fuel kit into a Dartmoor Baker W5 woodburner first remove the inner side bricks by

lifting the baffle plate up on one side above the side brick then slide the side brick out being careful

not to damage it. This needs to be repeated on the other side but this time you must hold the baffle

plate to stop it falling out. Once both side bricks are out the baffle plate can then be removed as well as

the log retainer. On each side of the base of the stove there are two bolts that need to be removed, this

requires a 17mm spanner or socket. The stove is now ready to accept the multi-fuel kit.

1. Bolt the two grate supports (G) by bolting them through the base holes each side. Make sure the

inside nut is adjusted so when the lower nuts are tightened the brackets are not digging into the outer

side brick. The side bricks should just move when the nuts are tight.

2. Fit the new fuel retainer making sure the bars sloping down, away from you towards the base of the

stove.

3. Slide the fuel retainer (B) up then slide the fire grate (A) under the fuel retainer and on top of the side

brackets (G) with the lip on the grate to the front and pointing up. Slide the fuel retainer back down to

sit on the fire grate

4. Re-fit the baffle plate (E) using the new shorter side bricks.

5. Fit the sloping thicker multi-fuel bricks (C) to each side of the fire grate.

6. Fit ash pan (F) under the fire grate.

Page 12 of 18

Dartmoor Baker W5 Eco with Multi-fuel kit installed

Now you are ready to install the multi-fuel kit.