- ページ 8
防犯カメラ HIKVISION ColorVu DS-2CE10KF3TのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION ColorVu DS-2CE10KF3T 19 ページ。 Bullet & turret camera
ページを印刷する
Loosen the trim ring to adjust the pan position
1).
[0° to 360°].
Loosen the thumbscrew to adjust the tilt
2).
position [0° to 180°].
Loosen the screw to adjust the rotation position
3).
[0° to 360°].
7. Tighten the trim ring and screws to finish the
installation.
2.1.2 Ceiling/Wall Mounting of Type II camera Without
Junction Box
Before you start:
Ceiling mounting and wall mounting are similar.
Following steps take ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
4. Route and connect the power cord and video cable.
5. Align the screw holes in the bracket to the ceiling,
and secure the camera with three PA4 × 25 screws
(supplied).
Figure 2-5 Secure Camera to Ceiling
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, turn the trim ring counterclockwise to loosen it
and adjust the positions according to the figure
below.
Rotation Position
[0° to 360°]
7. Turn the trim ring clockwise to lock the positions.
2.1.3 Ceiling/Wall Mounting with Junction Box
Before you start:
Figure 2-3 3-Axis Adjustment
Figure 2-4 Drill Template
Figure 2-6 3-Axis Adjustment
Screw Hole
Screw Hole
Screw Hole
templat e
3
Pan Position
[0° to 360°]
Trim Ring
Tilt Position
[0° to 90°]