- ページ 3
防犯カメラ HIKVISION D0TのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION D0T 15 ページ。 Audio turret camera
HIKVISION D0T にも： ユーザーマニュアル (17 ページ), ユーザーマニュアル (17 ページ), ユーザーマニュアル (11 ページ), ユーザーマニュアル (11 ページ), ユーザーマニュアル (17 ページ)
ページを印刷する
Safety Instruction
Warnings
In the use of the device, you must be in strict
compliance with the electrical safety regulations of
the nation and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950-1 standard and
IEC62368-1 standard. Refer to technical specifications
for detailed information.
Do not connect multiple devices to one power
adapter to avoid over-heating or a fire hazard caused
by overload.
The socket-outlet shall be installed near the
equipment and shall be easily accessible.
Make sure that the plug is firmly connected to the
power socket.
A readily accessible disconnect device shall be
incorporated external to the equipment.
An overcurrent protective device shall be
incorporated external to the equipment, not
exceeding the specification of the building.
An all-pole mains switch shall be incorporated in the
electrical installation of the building.
If smoke, odor or noise rise from the device, turn off
the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cautions
No naked flame sources, such as lighted candles,
should be placed on the equipment.
Install the equipment according to the instructions in
this manual.
To prevent injury, this equipment must be securely
attached to the floor/wall in accordance with the
installation instructions.
Do not touch the sharp edges or corners.
Do not drop the camera or subject it to physical
shock.
Do not touch senor modules with fingers.
Do not place the camera in extremely hot, cold (the
operating temperature shall be -40°C to 60°C), dusty
or damp locations, and do not expose it to high
electromagnetic radiation.
If cleaning is necessary, use clean cloth with a bit of
ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright
places.
The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnetic
radiation or extremely hot, cold, dusty or damp
environment.
To avoid heat accumulation, good ventilation is
required for the operating environment.
Keep the camera away from liquid while in use for
non-water-proof device.
While in delivery, the camera shall be packed in its
original packing, or packing of the same texture.