- ページ 2

スイッチ Maiwe MIGE2208G-8GTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Maiwe MIGE2208G-8GT 5 ページ。 Industrial ethernet switch

Maiwe MIGE2208G-8GT ユーザーマニュアル

Interface description

Unit:mm
33
Gigabit RJ45 port
Gigabit SFP port
Item
Crimp one end of the grounding screw with the cold-pressed
Ground screw
terminal. The other end of the grounding wire is connected to the
ground, and the grounding wire is not less than 2.5mm2
Support Dual DC12-48V or DC48 (36~72V).
Power interface
Support single power input AC85-264V or DC110-370V.
Supports automatic MDI/MDI-X connection. You can connect the switch
Ethernet RJ45 port
to terminal devices, servers, hubs, or other switches.
Fiber port
Gigabit fiber port could be SFP slot or DB9 port.
Din-rail kit
To fix the switch.
97
Gigabit RJ45 port
Description
The indicator description of the switch is shown in the following table.
Indicator lights
Ground screw
PWR
RUN
144
L/A1/G1
Power supply
The yellow light is the port rate indicator, and the green is the port
10/100/1000M
(Yellow)
LINK/ACT
(Green)
Status
Definition
System status LED
On
Power is connected and operating normally
Off
The power is unconnected or the system is abnormal
System operates normal
Blinking
System operates abnormal
Off
Fiber Status LED
On
The port has established a valid network connection
Blinking
The port has network activity
Off
The port has not established a valid network connection
Ethernet RJ45 Status LED
Each Ethernet RJ45 port has two indicator lights,
On
1000M work status (1000Base-TX)
10M/100Mwork statues(10Base-T or 100 Base-TX)
Off
On
The port has established a valid network connection
Blinking
The port has network activity
Off
The port has not established a valid network connection